Research and Development - R&D Archives - Page 2 of 2

Study presentation: ML-Optimized Beam-based Radio Coverage Processing in IEEE 802.11 WLAN Networks

In this post we present the work fully available under this link: ML-Optimized Beam-based Radio Coverage Processing in IEEE 802.11 WLAN Networks, about radio coverage processing in wlan and its optimi...

atlink'admin

August 15, 2020

Study presentation: A NURBS Based Technique for an Optimized Transmit Opportunity Map Processing in WLAN Networks

Dynamic Radio Resource Management helps overcome interferences in dense WLAN deployments. By processing data from upper-layers services, it could optimize and enrich end-to-end wireless client experie...

atlink'admin

August 15, 2020

Study presentation: An ML-optimized dRRM Solution for IEEE 802.11 Enterprise Wlan Networks

In this post we present our work on RRM solution and we present our proposed machine learning (ML) optimisation to a general operation of dynamic RRM. Pelease contact us for any question or report dir...

atlink'admin

August 15, 2020

Study presentation: A novel beamforming based model of coverage and transmission costing in IEEE 802.11 WLAN networks

In this post, we present the work on radio coverage in Wlans, accessible at this address: A novel beamforming based model of coverage and transmission costing in IEEE 802.11 WLAN networks, about how t...

atlink'admin

August 15, 2020

Study presentation: Cognitive directional cost-based transmit power control in IEEE 802.11 WLAN

In this post we present the work available at this link: Cognitive directional cost-based transmit power control in IEEE 802.11 WLAN, about the how to model the radio coverage area in enterprise Wlans...

atlink'admin

August 15, 2020

1 2

Transmit Power Control in IEEE 802.11 Cisco WLAN networks
TPC stands for Transmit Power Control. It’s a one of Cisco RRM, Radio Resources Management, techniques that are aimed at tackling interference, cross and co-channel, in Wlan networks. RRM: TPC, CHD and DCA It works tightly with CHD, Covergate Hole Detection, to optimize transmit power. TPC tends to minimize the transmit power and CHD to eliminate
10 security measures against 10 attacks in a LAN network – Part I
An Ethernet switch is the central element of a LAN network and operates at data link OSI layer. Every switch port defines a collision domain and can extend a broadcast or broadcast frame domain that is stopped by a router routed interface that operates at network OSI layer. By default switches support one broadcast domain
Understand how Aruba ARMizes your WLAN for sure!
Presenting ARM In this post, that is a part of a serie of post that discuss how Wlan to radio ressources management, we talk of Aruba way of doing it. The figure shows a simple wlan network of 6 AP or access points. This is heatmap showing that radio signal is very strong (in red)
Understand RIP Routing Timers All in One Shot!
This post is part of a series of posts about dynamic routing protocols and especially RIP. We’ll try to get a deep understanding of its operation and function as an introductory to dynamic routing logic in general. You’ll see that what we think easy may hide an incrementing complexity… a little introduction Berfore we start
DUAL route FSM Processing of EIGRP Queries
This blog is a part of series of posts about EIGRP routing protocol. Let’s recall that EIGRP is one of the so called IGP routing protocols. IGP stands for interior routing protocols as opposed to EGP or exterior routing protocols. In addition EIGRP is a hybrid as it borrows some similiarities to distance-vector and link-state

M	T	W	T	F	S	S
				1	2	3
4	5	6	7	8	9	10
11	12	13	14	15	16	17
18	19	20	21	22	23	24
25	26	27	28	29	30	31