Is it sufficient split-horizon rule to prevent RIP loops?
Per the split-horizon rule, don’t send an update back on the interface it was received on What is the challenge here? In addition to bandwidth usage and system resources consumption, […]
RIP: do not split it then… and unleach the power of the “network” command
In RIP domain routers R1 and R2 exchange information about loopback 0 and 1 networks Router RIP command “network 0.0.0.0” hints routers to add all ip enabled interfaces to the […]
Static routing metric
Both R1 and R3 advertise 13.13.13.13/32 network into RIP domain R3 is configured to offset all network updates via interface fa1/0 by 10
Static routing with intermediate address in Check Point
It is not possible to configure a static route with an intermediate address in a Check Point security gateway. BUT …